NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Quality of Service (QoS) Commands 10-27
202-10102-01, May 2005
Non-Conform COS This field displays the CoS mark value if the non-conform action is set-
cos-transmit.
Non-Conform DSCP Value This field displays the DSCP mark value if the non-conform action
is set-dscp-transmit.
Non-Conform IP Precedence Value This field displays the IP Precedence mark value if the
non-conform action is set-prec-transmit.
Policing Style This field denotes the style of policing, if any, used (simple).
Redirect Forces a classified traffic stream to a specified egress port (physical
port). This can occur in addition to any marking or policing action. It
may also be specified along with a QoS queue assignment.
If the Policy Name is not specified this command displays a list of all defined DiffServ policies. The
following fields are displayed:
Policy Name The name of this policy. (The order in which the policies are displayed
is not necessarily the same order in which they were created.)
Policy Type The policy type (Only inbound is supported).
Class Members List of all class names associated with this policy.
show diffserv service
This command displays policy service information for the specified interface and direction. The
<slot/port> parameter specifies a valid slot/port number for the system.
Format
show diffserv service <slot/port> in
Mode Privileged EXEC
DiffServ Admin Mode The current setting of the DiffServ administrative mode. An attached
policy is only in effect on an interface while DiffServ is in an enabled
mode.
Interface Valid slot and port number separated by forward slashes.
Direction The traffic direction of this interface service.
Operational Status The current operational status of this DiffServ service interface.
Policy Name The name of the policy attached to the interface in the indicated direc-
tion.
Policy Details Attached policy details, whose content is identical to that described for
the show policy-map <policymapname> command (content not
repeated here for brevity).