NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Switching Commands 8-21
202-10102-01, May 2005
serial baudrate
This command specifies the communication rate of the terminal interface. The supported rates are
1200, 2400, 4800, 9600, 19200, 38400, 57600, 115200.
Default
9600
Format serial baudrate {1200 | 2400 | 4800 | 9600 | 19200 |
38400 | 57600 | 115200}
Mode Line Config
no serial baudrate
This command sets the communication rate of the terminal interface.
Format
no serial baudrate
Mode Line Config
serial timeout
This command specifies the maximum connect time (in minutes) without console activity. A value
of 0 indicates that a console can be connected indefinitely. The time range is 0 to 160.
Default
5
Format serial timeout <0-160>
Mode Line Config
no serial timeout
This command sets the maximum connect time (in minutes) without console activity.
Format
no serial timeout
Mode Line Config
set prompt
This command changes the name of the prompt. The length of name may be up to 64 alphanumeric
characters.
Format
set prompt <prompt string>
Mode Privileged EXEC