NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
10-22 Quality of Service (QoS) Commands
202-10102-01, May 2005
action {drop | set-prec-transmit <0-7> | set-dscp-
transmit <0-63> | set-cos-transmit <0-7> | transmit}]}
Mode Policy-Class-Map Config
Incompatibilities Drop, Mark (all forms)
policy-map
This command establishes a new DiffServ policy. The <policyname> parameter is a case-sensitive
alphanumeric string from 1 to 31 characters uniquely identifying the policy. The type of policy is
specific to the inbound traffic direction as indicated by the in parameter.
1. The policy type dictates which of the individual policy attribute commands are valid within
the policy definition.
1. The CLI mode is changed to Policy-Map Config when this command is successfully executed.
Format
policy-map <policyname> in
Mode Global Config
no policy-map
This command eliminates an existing DiffServ policy. The <policyname> parameter is the name of
an existing DiffServ policy. This command may be issued at any time. If the policy is currently
referenced by one or more interface service attachments, this delete attempt fails.
Format
no policy-map <policyname>
Mode Global Config
policy-map rename
This command changes the name of a DiffServ policy. The <policyname> is the name of an
existing DiffServ class. The <
newpolicyname> parameter is a case-sensitive alphanumeric string
from 1 to 31 characters uniquely identifying the policy.
Format
policy-map rename <policyname> <newpolicyname>
Mode Global Config
Service Commands
The 'service' command set is used in DiffServ to define: