NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Switching Commands 8-99
202-10102-01, May 2005
Platforms that support priority to traffic class mapping on a per-port basis:
Format show classofservice dot1pmapping <slot/port>
Platforms that do not support priority to traffic class mapping on a per-port basis:
Formatshow classofservice dot1pmapping
Mode
Privileged EXEC and User EXEC
vlan port priority all
This command configures the port priority assigned for untagged packets for all ports presently
plugged into the device. The range for the priority is 0-7. Any subsequent per port configuration
will override this configuration setting.
Format
vlan port priority all <priority>
Mode Global Config
vlan priority
This command configures the default 802.1p port priority assigned for untagged packets for a
specific interface. The range for the priority is 0-7
Default
0
Format vlan priority <priority>
Mode Interface Config
GARP Commands
This chapter provides a detailed explanation of the GARP commands. The commands are divided
into two functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration setting.