NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
8-48 Switching Commands
202-10102-01, May 2005
show port
This command displays port information.
Format
show port {<slot/port> | all}
Mode Privileged EXEC
Slot/Port Valid slot and port number separated by forward slashes.
Type If not blank, this field indicates that this port is a special type of port.
The possible values are:
Mon - this port is a monitoring port. Look at the Port Monitoring
screens to find out more information.
Lag - this port is a member of a port-channel (LAG).
Probe - this port is a probe port.
Admin Mode Selects the Port control administration state. The port must be enabled
in order for it to be allowed into the network. - May be enabled or dis-
abled. The factory default is enabled.
Physical Mode Selects the desired port speed and duplex mode. If auto-negotiation sup-
port is selected, then the duplex mode and speed will be set from the
auto-negotiation process. Note that the port's maximum capability (full
duplex -100M) will be advertised. Otherwise, this object will determine
the port's duplex mode and transmission rate. The factory default is
Auto.
Physical Status Indicates the port speed and duplex mode.
Link Status Indicates whether the Link is up or down.
Link Trap This object determines whether or not to send a trap when link status
changes. The factory default is enabled.
LACP Mode Displays whether LACP is enabled or disabled on this port.
show port protocol
This command displays the Protocol-Based VLAN information for either the entire system, or for
the indicated Group.
Format
show port protocol <groupid | all>
Mode Privileged EXEC
Group Name This field displays the group name of an entry in the Protocol-based VLAN
table.