User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
10-8 Quality of Service (QoS) Commands
202-10102-01, May 2005
show ip access-lists
This command displays an IP ACL <accesslistnumber> is the number used to identify the IP ACL.
Format
show ip access-lists <accesslistnumber>
Modes Privileged EXEC
Rule Number This displays the number identifier for each rule that is defined for the
IP ACL.
Action This displays the action associated with each rule. The possible values
are Permit or Deny.
Protocol This displays the protocol to filter for this rule.
Source IP Address This displays the source IP address for this rule.
Source IP Mask This field displays the source IP Mask for this rule.
Source Ports This field displays the source port for this rule.
Destination IP Address This displays the destination IP address for this rule.
Destination IP Mask This field displays the destination IP Mask for this rule.
Destination Ports This field displays the destination port for this rule.
Service Type Field Match This field indicates whether an IP DSCP, IP Precedence, or IP TOS
match condition is specified for this rule.
Service Type Field Value This field indicates the value specified for the Service Type Field
Match (IP DSCP, IP Precedence, or IP TOS).
show access-lists
This command displays IP ACLs and MAC access control lists information for a designated
interface and direction.
Format
show access-lists interface <slot/port> in
Modes Privileged EXEC
ACL Type Type of access list (IP or MAC).
ACL ID Access List name for a MAC access list or the numeric identifier for an
IP access list.
Sequence Number An optional sequence number may be specified to indicate the order of
this access list relative to other access lists already assigned to this inter-
face and direction. A lower number indicates higher precedence order. If
a sequence number is already in use for this interface and direction, the
specified access list replaces the currently attached access list using that
To Next Page
Loading...
