NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Switching Commands 8-69
202-10102-01, May 2005
Default enabled; severitylevel - critical
Format logging persistent [<severitylevel>]
Mode Global Config
no logging persistent
This command disables logging. It does not clear the contents of the log.
Format
no logging persistent
Mode Global Config
logging host
This command enables logging to a host where up to eight hosts can be configured. AddressType
can be ipv4 or dns, port can be of a value from
Default
Port - 514; Level - Critical;
Format logging host <ipaddress> <addresstype> [port <port>]
[level <severitylevel>]
Mode Global Config
logging host remove
This command disables logging to host. See “show logging hosts” on page 72. for a list of host
indices.
Format
logging host remove <hostindex>
Mode Global Config
logging port
This command sets the local port number of the LOG client for logging messages. The <portid>
can be in the range from 1 to 65535.
Default
514
Format logging port <portid>
Mode Global Config