NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
8-36 Switching Commands
202-10102-01, May 2005
addport
This command adds one port to the port-channel (LAG). The first interface is a logical slot and
port number of a configured port-channel.
Note: Before adding a port to a port-channel, set the physical mode of the port. See ‘speed’
command.
Format
addport <logical slot/port>
Mode Interface Config
cablestatus
This command tests the status of the cable attached to an interface.
Format
cablestatus <slot/port>
Mode Privileged EXEC
auto-negotiate
This command enables automatic negotiation on a port. The default value is enable.
Format
auto-negotiate
Mode Interface Config
no auto-negotiate
This command disables automatic negotiation on a port.
Note: Automatic sensing is disabled when automatic negotiation is disabled.
Format
no auto-negotiate
Mode Interface Config
auto-negotiate all
This command enables automatic negotiation on all ports. The default value is enable.
Format
auto-negotiate all
Mode Global Config