NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
8-102 Switching Commands
202-10102-01, May 2005
Note: This command has an effect only when GVRP is enabled.
Format no set garp timer leave all
Mode Global Config
set garp timer leaveall
This command sets how frequently Leave All PDUs are generated per port. A Leave All PDU
indicates that all registrations will be unregistered. Participants would need to rejoin in order to
maintain registration. The value applies per port and per GARP participation. The time may range
from 200 to 6000 (centiseconds). The value 1000 centiseconds is 10 seconds.
Note: This command has an effect only when GVRP is enabled.
Default 1000
Format set garp timer leaveall <200-6000>
Mode Interface Config
no set garp timer leaveall
This command sets how frequently
Leave All PDUs are generated per port to 1000 centiseconds (10
seconds). .
Note: This command has an effect only when GVRP is enabled.
Format
no set garp timer leaveall
Mode Interface Config
set garp timer leaveall all
This command sets how frequently Leave All PDUs are generated for all ports. A Leave All PDU
indicates that all registrations will be unregistered. Participants would need to rejoin in order to
maintain registration. The value applies per port and per GARP participation. The time may range
from 200 to 6000 (centiseconds). The value 1000 centiseconds is 10 seconds.
Note: This command has an effect only when GVRP is enabled.
Default
1000
Format set garp timer leaveall all <200-6000>
Mode Global Config