NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
8-16 Switching Commands
202-10102-01, May 2005
Mode Line Config
session-limit
This command specifies the maximum number of simultaneous outbound telnet sessions. A value
of 0 indicates that no outbound telnet session can be established.
Default
5
Format session-limit <0-5>
Mode Line Config
no session-limit
This command sets the maximum number of simultaneous outbound telnet sessions to the default
value.
Format
no session-limit
Mode Line Config
session-timeout
This command sets the outbound telnet session timeout value.The timeout value unit of time is
minutes. A value of 0 indicates that a session remains active indefinitely.
Default 0
Format
session-timeout <0-160>
Mode Line Config
no session-timeout
This command sets the outbound telnet session timeout value to the default. The timeout value unit
of time is minutes.
Format
no session-timeout
Mode Line Config