NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
8-106 Switching Commands
202-10102-01, May 2005
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration setting.
set gmrp adminmode
This command enables GARP Multicast Registration Protocol (GMRP) on the system. The default
value is disable.
Format
set gmrp adminmode
Mode Privileged EXEC
no set gmrp adminmode
This command disables GARP Multicast Registration Protocol (GMRP) on the system.
Format
no set gmrp adminmode
Mode Privileged EXEC
set gmrp interfacemode
This command enables GARP Multicast Registration Protocol on a selected interface. If an
interface which has GARP enabled is enabled for routing or is enlisted as a member of a port-
channel (LAG), GARP functionality will be disabled on that interface. GARP functionality will
subsequently be re-enabled if routing is disabled and port-channel (LAG) membership is removed
from an interface that has GARP enabled.
Default
disabled
Format set gmrp interfacemode
Mode Interface Config
no set gmrp interfacemode
This command disables GARP Multicast Registration Protocol on a selected interface. If an
interface which has GARP enabled is enabled for routing or is enlisted as a member of a port-
channel (LAG), GARP functionality will be disabled on that interface. GARP functionality will
subsequently be re-enabled if routing is disabled and port-channel (LAG) membership is removed
from an interface that has GARP enabled.
Format
no set gmrp interfacemode
Mode Interface Config