NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Switching Commands 8-19
202-10102-01, May 2005
Mode Privileged EXEC
network mac-type
This command specifies whether the burned in MAC address or the locally-administered MAC
address is used.
Default
burnedin
Format network mac-type {local | burnedin}
Mode Privileged EXEC
no network mac-type
This command resets the value of MAC address to its default.
Format
no network mac-type
Mode Privileged EXEC
network parms
This command sets the IP Address, subnet mask and gateway of the router. The IP Address and the
gateway must be on the same subnet.
Format
network parms <ipaddr> <netmask> [<gateway>]
Mode Privileged EXEC
network protocol
This command specifies the network configuration protocol to be used. If you modify this value
change is effective immediately. The parameter
bootp indicates that the switch periodically sends
requests to a Bootstrap Protocol (BootP) server or a dhcp server until a response is received.
none
indicates that the switch should be manually configured with IP information.
Default
none
Format network protocol {none | bootp | dhcp}
Mode Privileged EXEC