NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Switching Commands 8-41
202-10102-01, May 2005
monitor session 1 source interface
This command adds a mirrored port (source port) to a session identified with <session-id>.
Note: The <session-id> parameter is an integer value used to identify the session. In the current
version of the software, the <session-id> parameter is always 1.
Default
None
Format monitor session <session-id> source interface
<slot/port>
Mode Global config
no monitor session 1 source interface
This command removes the specified mirrored port (source port) from the session.
Note: The <session-id> parameter is an integer value used to identify the session. In the current
version of the software, the <session-id> parameter is always 1.
Format
no monitor session <session-id> source interface
<slot/port>
Mode Global config
no monitor
This command removes all the source ports and a destination port and restores the default value for
mirroring session mode for all the configured sessions.
Note: This is a stand-alone “no” command. This command does not have a “normal” form.
Default
enabled
Format no monitor
Mode Global config
no monitor session 1
This command will remove all the source ports and a destination port of the mirroring session and
restore the default value for mirroring session mode.
Note: The <session-id> parameter is an integer value used to identify the session. In the current
version of the software, the <session-id> parameter is always 1.