NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Security Commands 9-23
202-10102-01, May 2005
ip ssh protocol
This command is used to set or remove protocol levels (or versions) for SSH. Either SSH1 (1),
SSH2 (2), or both SSH 1 and SSH 2 (1 and 2) can be set.
Default
1 and 2
Format ip ssh protocol [1] [2]
Mode Privileged EXEC
sshcon maxsessions
This command specifies the maximum number of SSH connection sessions that can be
established. A value of 0 indicates that no ssh connection can be established. The range is 0 to 5.
Default
5
Format telnetcon maxsessions <0-5>
Mode Privileged EXEC
no sshcon maxsessions
This command sets the maximum number of allowed SSH connection sessions to the default
value.
Format
no telnetcon maxsessions
Mode Privileged EXEC
sshcon timeout
This command sets the SSH connection session timeout value, in minutes. A session is active as
long as the session has been idle for the value set. The time is a decimal value from 1 to 160.
Changing the timeout value for active sessions does not become effective until the session is re
accessed. Also, any keystroke activates the new timeout duration.
Default
5
Format telnetcon timeout <1-160>
Mode Privileged EXEC