User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
10-32 Quality of Service (QoS) Commands
202-10102-01, May 2005
Modes Global Config
Interface Config
show classofservice dot1p-mapping
This command displays the current Dot1p (802.1p) priority mapping to internal traffic classes for a
specific interface. The slot/port parameter is optional and is only valid on platforms that support
independent per-port class of service mappings. If specified, the 802.1p mapping table of the
interface is displayed. If omitted, the most recent global configuration settings are displayed.
Format
show classofservice dot1p-mapping [slot/port]
Mode Privileged EXEC
The following information is repeated for each user priority.
User Priority
The 802.1p user priority value.
Traffic Class The traffic class internal queue identifier to which the user priority value
is mapped.
show classofservice ip-precedence-mapping
This command displays the current IP Precedence mapping to internal traffic classes for a specific
interface. The slot/port parameter is optional and is only valid on platforms that support
independent per-port class of service mappings. If specified, the IP Precedence mapping table of
the interface is displayed. If omitted, the most recent global configuration settings are displayed.
Format
show classofservice ip-precedence-mapping [slot/port]
Mode Privileged EXEC
The following information is repeated for each user priority.
IP Precedence
The IP Precedence value.
Traffic Class The traffic class internal queue identifier to which the IP Precedence
value is mapped.
To Next Page
Loading...
