NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
8-24 Switching Commands
202-10102-01, May 2005
Network Configuration Protocol Current Indicates which network protocol is being used.
The options are bootp | dhcp | none.
Java Mode Specifies if the switch should allow access to the Java applet in the
header frame. Enabled means the applet can be viewed. The factory
default is disabled.
Management VLAN ID Specifies the management VLAN ID.
show telnetcon
This command displays telnet settings.
Format
show telnetcon
Mode Privileged EXEC and User EXEC
Remote Connection Login Timeout (minutes) This object indicates the number of min-
utes a remote connection session is allowed to remain inactive before
being logged off. A zero means there will be no timeout. May be speci-
fied as a number from 0 to 160. The factory default is 5.
Maximum Number of Remote Connection Sessions This object indicates the number of
simultaneous remote connection sessions allowed. The factory default is
5.
Allow New Telnet Sessions Indicates that new telnet sessions will not be allowed when set to
no. The factory default value is yes.
show serial
This command displays serial communication settings for the switch.
Format
show serial
Mode Privileged EXEC and User EXEC
Serial Port Login Timeout (minutes) Specifies the time, in minutes, of inactivity on a Serial
port connection, after which the Switch will close the connection. Any
numeric value between 0 and 160 is allowed, the factory default is 5. A
value of 0 disables the timeout.
Baud Rate The default baud rate at which the serial port will try to connect. The
available values are 1200, 2400, 4800, 9600, 19200, 38400,57600, and
115200 baud. The factory Default is 9600 baud.
Character Size The number of bits in a character. The number of bits is always 8.