NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
10-30 Quality of Service (QoS) Commands
202-10102-01, May 2005
classofservice ip-precedence-mapping
This command maps an IP precedence value to an internal traffic class. The ipprecedence and
trafficclass can both range from 0-7, although the actual number of available traffic classes
depends on the platform. The 'no' form of this command is not supported.
Format
classofservice ip-precedence-mapping <ipprecedence>
<trafficclass>
Modes Global Config
Interface Config
classofservice trust
This command sets the class of service trust mode of an interface. The mode can be set to trust one
of the Dot1p (802.1p), IP Precedence, or IP DSCP packet markings.
Format
classofservice trust <dot1p/ip-precedence>
Mode Global Config
Interface Config
no classofservice trust
This command sets the interface mode to untrusted.
Format
no classofservice trust
Modes Global Config
Interface Config
cos-queue min-bandwidth
This command specifies the minimum transmission bandwidth guarantee for each interface queue.
The total number of queues supported per interface is platform specific. A value from 0-100
(percentage of link rate) must be specified for each supported queue, with 0 indicating no
guaranteed minimum bandwidth. The sum of all values entered must not exceed 100.
Format
cos-queue min-bandwidth <bw-0> <bw-1> … <bw-n>
Modes Global Config
Interface Config