NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Switching Commands 8-75
202-10102-01, May 2005
no sntp unicast client poll-retry
This command will reset the poll retry for SNTP unicast clients to its default value.
Format
no sntp unicast client poll-retry
Mode Global Config
sntp multicast client poll-interval
This command will set the poll interval for SNTP multicast clients in seconds as a power of two
where <poll-interval> can be a value from 6 to 16.
Default
6
Format sntp multicast client poll-interval <poll-interval>
Mode Global Config
no sntp multicast client poll-interval
This command will reset the poll interval for SNTP multicast clients to its default value.
Format
no sntp multicast client poll-interval
Mode Global Config
sntp server
This command configures an SNTP server (with a maximum of three) where the server address
can be an ip address or a domain name and the address type either ipv4 or dns. The optional
priority can be a value of 1-3, the version a value of 1-4, and the port id a value of 1-65535.
Format
sntp server <ipaddress/domain-name> <addresstype>
[<priority> [<version> [<portid>]]]
Mode Global Config
no sntp server
This command deletes an server from the configured SNTP servers.
Format
no sntp server remove <ipaddress/domain-name>
Mode Global Config