NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
8-28 Switching Commands
202-10102-01, May 2005
Default Two default community names: Public and Private. You can replace
these default community names with unique identifiers for each com-
munity. The default values for the remaining four community names are
blank.
Format snmp-server community <name>
Mode Global Config
no snmp-server community
This command removes this community name from the table. The name is the community name to
be deleted.
Format
no snmp-server community <name>
Mode Global Config
snmp-server community ipaddr
This command sets a client IP address for an SNMP community. The address is the associated
community SNMP packet sending address and is used along with the client IP mask value to
denote a range of IP addresses from which SNMP clients may use that community to access the
device. A value of 0.0.0.0 allows access from any IP address. Otherwise, this value is ANDed with
the mask to determine the range of allowed client IP addresses. The name is the applicable
community name.
Default
0.0.0.0
Format snmp-server community ipaddr <ipaddr> <name>
Mode Global Config
no snmp-server community ipaddr
This command sets a client IP address for an SNMP community to 0.0.0.0. The name is the
applicable community name.
Format
no snmp-server community ipaddr <name>
Mode Global Config