NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
8-20 Switching Commands
202-10102-01, May 2005
telnetcon maxsessions
This command specifies the maximum number of telnet connection sessions that can be
established. A value of 0 indicates that no telnet connection can be established. The range is 0 to 5.
Default
5
Format telnetcon maxsessions <0-5>
Mode Privileged EXEC
no telnetcon maxsessions
This command sets the maximum number of telnet connection sessions that can be established to
the default value.
Format
no telnetcon maxsessions
Mode Privileged EXEC
telnetcon timeout
This command sets the telnet connection session timeout value, in minutes. A session is active as
long as the session has not been idle for the value set. The time is a decimal value from 1 to 160.
Note: Changing the timeout value for active sessions does not become effective until the session is
reaccessed. Also, any keystroke activates the new timeout duration.
Default
5
Format telnetcon timeout <1-160>
Mode Privileged EXEC
no telnetcon timeout
This command sets the telnet connection session timeout value to the default.
Note: Changing the timeout value for active sessions does not become effective until the session is
reaccessed. Also, any keystroke activates the new timeout duration.
Format
no telnetcon timeout
Mode Privileged EXEC