NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Switching Commands 8-53
202-10102-01, May 2005
no vlan port acceptframe all
This command sets the frame acceptance mode for all interfaces to Admit All. For Admit All
mode, untagged frames or priority frames received on this interface are accepted and assigned the
value of the interface VLAN ID for this port. With either option, VLAN tagged frames are
forwarded in accordance with the IEEE 802.1Q VLAN Specification.
Format
no vlan port acceptframe all
Mode Global Config
vlan port ingressfilter all
This command enables ingress filtering for all ports. If ingress filtering is disabled, frames
received with VLAN IDs that do not match the VLAN membership of the receiving interface are
admitted and forwarded to ports that are members of that VLAN.
Default
disabled
Format vlan port ingressfilter all
Mode Global Config
no vlan port ingressfilter all
This command disables ingress filtering for all ports. If ingress filtering is disabled, frames
received with VLAN IDs that do not match the VLAN membership of the receiving interface are
admitted and forwarded to ports that are members of that VLAN.
Format
no vlan port ingressfilter all
Mode Global Config
vlan port pvid all
This command changes the VLAN ID for all interface.
Default
1
Format vlan port pvid all <1-4094>
Mode Global Config
no vlan port pvid all
This command sets the VLAN ID for all interfaces to 1.