NETGEAR ProSafe GSM7248

To Next Page

To Previous Page

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4

8-58 Switching Commands

202-10102-01, May 2005

show vlan

This command displays detailed information, including interface information, for a specific

VLAN. The ID is a valid VLAN identification number

Format

show vlan <vlanid>

Modes Privileged EXEC

User EXEC

VLAN ID There is a VLAN Identifier (VID) associated with each VLAN. The

range of the VLAN ID is 1 to 4094.

VLAN Name A string associated with this VLAN as a convenience. It can be up to 32

alphanumeric characters long, including blanks. The default is blank.

VLAN ID 1 always has a name of `Default`. This field is optional.

VLAN Type Type of VLAN, which can be Default, (VLAN ID = 1), a static (one that

is configured and permanently defined), or Dynamic (one that is created

by GVRP registration).

Slot/Port Valid slot and port number separated by forward slashes. It is possible to

set the parameters for all ports by using the selectors on the top line.

Current Determines the degree of participation of this port in this VLAN. The

permissible values are:

Include - This port is always a member of this VLAN. This is equiva-

lent to registration fixed in the IEEE 802.1Q standard.

Exclude - This port is never a member of this VLAN. This is equivalent

to registration forbidden in the IEEE 802.1Q standard.

Autodetect - Specifies to allow the port to be dynamically registered in

this VLAN via GVRP. The port will not participate in this VLAN unless

a join request is received on this port. This is equivalent to registration

normal in the IEEE 802.1Q standard.

Configured Determines the configured degree of participation of this port in this

VLAN. The permissible values are: