NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Quality of Service (QoS) Commands 10-15
202-10102-01, May 2005
To specify the match condition as a single keyword, the value for <portkey> is one of the supported
port name keywords. The currently supported <
portkey> values are: domain, echo, ftp, ftpdata, http, smtp,
snmp, telnet, tftp, www
. Each of these translates into its equivalent port number.
To specify the match condition using a numeric notation, one layer 4 port number is required. The
port number is an integer from 0 to 65535.
Default
none
Format match dstl4port {portkey | <0-65535>}
Mode Class-Map Config
match ip dscp
This command adds to the specified class definition a match condition based on the value of the IP
DiffServ Code Point (DSCP) field in a packet, which is defined as the high-order six bits of the
Service Type octet in the IP header (the low-order two bits are not checked). The <
dscpval> value is
specified as either an integer from 0 to 63, or symbolically through one of the following keywords:
af11, af12, af13, af21, af22, af23, af31, af32, af33, af41, af42, af43, be, cs0, cs1, cs2, cs3, cs4, cs5, cs6, cs7, ef.
Note: The ip dscp, ip precedence, and ip tos match conditions are alternative ways to specify a
match criterion for the same Service Type field in the IP header, but with a slightly different user
notation.
Default
none
Format match ip dscp <dscpval>
Mode Class-Map Config
match ip precedence
This command adds to the specified class definition a match condition based on the value of the IP
Precedence field in a packet, which is defined as the high-order three bits of the Service Type octet
in the IP header (the low-order five bits are not checked). The precedence value is an integer from
0 to 7.
Note: The ip dscp, ip precedence, and ip tos match conditions are alternative ways to specify a
match criterion for the same Service Type field in the IP header, but with a slightly different user
notation.
Default
none
Format match ip precedence <0-7>
Mode Class-Map Config