NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
8-30 Switching Commands
202-10102-01, May 2005
Format no snmp-server community mode <name>
Mode Global Config
snmp-server community ro
This command restricts access to switch information. The access mode is read-only (also called
public).
Format
snmp-server community ro <name>
Mode Global Config
snmp-server community rw
This command restricts access to switch information. The access mode is read/write (also called
private).
Format
snmp-server community rw <name>
Mode Global Config
snmp-server enable traps
This command enables the Authentication Flag.
Default
enabled
Format snmp-server enable traps
Mode Global Config
no snmp-server enable traps
This command disables the Authentication Flag.
Format
no snmp-server enable traps
Mode Global Config
snmp-server enable traps bcaststorm
This command enables the broadcast storm trap. When enabled, broadcast storm traps are sent
only if the broadcast storm recovery mode setting associated with the port is enabled .