NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
8-22 Switching Commands
202-10102-01, May 2005
serviceport ip
This command sets the IP address, the netmask and the gateway of the router.
Format
serviceport ip <ipaddr> <netmask> [gateway]
Mode Privileged EXEC
serviceport protocol
This command specifies the servicePort configuration protocol. If you modify this value, the
change takes effect immediately.
Format
serviceport protocol {none | bootp | dhcp}
Mode Privileged EXEC
show telnet
This command displays the current outbound telnet settings.
Format
show telnet
Modes Privileged EXEC
User EXEC
Outbound Telnet Login Timeout (in minutes) Indicates the number of minutes an out-
bound telnet session is allowed to remain inactive before being logged
off. A value of 0, which is the default, results in no timeout.
Maximum Number of Outbound Telnet Sessions Indicates the number of simultaneous
outbound telnet connections allowed.
Allow New Outbound Telnet Sessions Indicates whether outbound telnet sessions will be
allowed.
show forwardingdb agetime
This command displays the timeout for address aging. In an IVL system, the [fdbid | all] parameter
is required.
Default
all
Format show forwardingdb agetime [fdbid | all]
Mode Privileged EXEC