NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
10-24 Quality of Service (QoS) Commands
202-10102-01, May 2005
Show Commands
The 'show' command set is used in DiffServ to display configuration and status information for:
• Classes
• Policies
•Services
This information can be displayed in either summary or detailed formats. The status information is
only shown when the DiffServ administrative mode is enabled; it is suppressed otherwise.
There is also a 'show' command for general DiffServ information that is available at any time.
show class-map
This command displays all configuration information for the specified class. The <class-name> is
the name of an existing DiffServ class.
Format
show class-map <class-name>
Mode Privileged EXEC
User EXEC
If the class-name is specified the following fields are displayed:
Class Name
The name of this class.
Class Type A class type of ‘all’ means every match criterion defined for the class is
evaluated simultaneously and must all be true to indicate a class match.
Match Criteria The Match Criteria fields are only displayed if they have been config-
ured. They are displayed in the order entered by the user. The fields are
evaluated in accordance with the class type. The possible Match Criteria
fields are: Class of Service, Destination IP Address, Destination Layer 4
Port, Destination MAC Address, Ethertype, Every, IP DSCP, IP Prece-
dence, IP TOS, Protocol Keyword, Reference Class, Source IP
Address, Source Layer 4 Port, Source MAC Address, VLAN.
Values This field displays the values of the Match Criteria.
If the Class Name is not specified, this command displays a list of all defined DiffServ classes. The
following fields are displayed:
Class Name
The name of this class. (Note that the order in which classes are dis-
played is not necessarily the same order in which they were created.)