NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Switching Commands 8-13
202-10102-01, May 2005
show msglog
This command displays the message log maintained by the switch. The message log contains
system trace information.
The trap log contains a maximum of 256 entries that wrap.
Format
show msglog
Mode Privileged EXEC
Message The message that has been logged.
Note: Message log information is not retained across a switch reset.
show running-config
This command is used to display/capture the current setting of different protocol packages
supported on switch. This command displays/captures only commands with settings/
configurations with values that differ from the default value. The output is displayed in script
format, which can be used to configure another switch with the same configuration.
When a script name is provided, the output is redirected to a configuration script. The option [all]
will also enable the display/capture of all commands with settings/configurations that include
values that are same as the default values. If the optional <scriptname> is provided with a file
name extension of “.scr”, the output will be redirected to a script file.
Format
show running-config [all] [<scriptname>]
Mode Privileged EXEC
If static capability is enabled:
port-channel staticcapability The device has static capability enabled.
show sysinfo
This command displays switch information.
Format
show sysinfo
Mode Privileged EXEC
Switch Description Text used to identify this switch.
System Name Name used to identify the switch.