NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
8-34 Switching Commands
202-10102-01, May 2005
Note: This command is valid only when the Link Up/Down Flag is enabled. See ‘snmp-server enable traps
linkmode’ command).
Format no snmp trap link-status
Mode Interface Config
snmp trap link-status all
This command enables link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled (see “snmp-server enable traps
linkmode” ).
Format snmp trap link-status all
Mode Global Config
no snmp trap link-status all
This command disables link status traps for all interfaces.
Note: This command is valid only when the Link Up/Down Flag is enabled (see “snmp-server enable traps
linkmode”).
Format no snmp trap link-status all
Mode Global Config
Management VLAN Command
This command is used to set the Management VLAN.
network mgmt_vlan
This command configures the Management VLAN ID.
Default
1
Format network mgmt_vlan <1-4094>
Mode Privileged EXEC