NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Quick Start up 6-5
202-10102-01, May 2005
Quick Start up Uploading from Switch to Out-of-Band PC (Only
XMODEM)
Quick Start up Downloading from Out-of-Band PC to Switch
(Only XMODEM)
Table 6-5. Quick Start up Uploading from Switch to Out-of-Band PC (XMODEM)
Command Details
copy {
nvram:startup-config |
nvram:errorlog |
nvram:msglog |
nvram:traplog} <url>
The types are:
config - configuration file
errorlog - error log
system trace - system trace
traplog - trap log
The URL must be specified as:
xmodem:filepath/fileName
This starts the upload and also displays the mode of
uploading and the type of upload it is and confirms the
upload is taking place.
For example:
If the user is using HyperTerminal, the user must
specify where the file is going to be received by the
PC.
Table 6-6. Quick Start up Downloading from Out-of-Band PC to Switch (Only XMODEM)
Command Details
copy <url> {nvram:startup-config |
system:image}
Sets the download datatype to be an image or
config file.
The URL must be specified as:
xmodem:filepath/fileName
For example:
If the user is using HyperTerminal, the user
must specify which file is to be sent to the
switch.
The Switch will restart automatically once the
code has been downloaded.