User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
8-72 Switching Commands
202-10102-01, May 2005
show logging hosts
This command displays all configured logging hosts.
Format
show logging hosts
Mode Privileged EXEC
Host Index
(Used for deleting hosts)
Host IP Address IP Address of the configured server.
Address Type Address Type of Server.
Severity Level The minimum severity to log to the specified address.
Port Server Port Number.This is the port on the local host from which syslog mes-
sages are sent.
Host Status The state of logging to configured syslog hosts. If the status is disable,
no logging occurs.
Log Messages: The log messages appear here.
Simple Network Time Protocol (SNTP) Commands
This section provides a detailed explanation of the SNTP commands. The commands are divided
into two functional groups:
• Show commands display spanning tree settings, statistics, and other information.
• Configuration Commands configure features and options of the switch. For every
configuration command there is a show command that displays the configuration setting.
sntp broadcast client poll-interval
This command will set the poll interval for SNTP broadcast clients in seconds as a power of two
where <poll-interval> can be a value from 6 to 16.
Default
6
Format sntp broadcast client poll-interval <poll-interval>
Mode Global Config
To Next Page
Loading...
