NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Switching Commands 8-103
202-10102-01, May 2005
no set garp timer leaveall all
This command sets how frequently
Leave All PDUs are generated for all ports to 1000 centiseconds
(10 seconds). .
Note: This command has an effect only when GVRP is enabled.
Format
no set garp timer leaveall all
Mode Global Config
show garp
This command displays Generic Attributes Registration Protocol (GARP) information.
Format
show garp
Mode Privileged EXEC and User EXEC
GMRP Admin Mode This displays the administrative mode of GARP Multicast Registration Protocol
(GMRP) for the system.
GVRP Admin Mode This displays the administrative mode of GARP VLAN Registration Protocol
(GVRP) for the system
GARP VLAN Registration Protocol (GVRP) Commands
This chapter provides a detailed explanation of the GVRP commands. The commands are divided
into two functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration setting.
set gvrp adminmode
This command enables GVRP.
Default
disabled
Format set gvrp adminmode
Mode Privileged EXEC