NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Switching Commands 8-91
202-10102-01, May 2005
Example :a3:4f:22:0c / a3 4f 22 0c / a34f.220c.9fed The <address> specifies an IP address.
Default
none
Format option <code> {ascii string | hex <string1>
[<string2>...<string8> ] | ip <address1>
[<address2>...<address8> ]}
Mode DHCP Pool Config
no option
This command removes the options.
Format
no option <code>
Mode DHCP Pool Config
show ip dhcp binding
This command displays address bindings for the specific IP address on the DHCP server. If no IP
address is specified, the bindings corresponding to all the addresses are displayed.
Format
show ip dhcp binding [address]
Modes Privileged EXEC
User EXEC
IP address The IP address of the client.
Hardware Address The MAC Address or the client identifier.
Lease expiration The lease expiration time of the IP Address assigned to the client.
Type The manner in which IP Address was assigned to the client.
show ip dhcp global configuration
This command displays address bindings for the specific IP address on the DHCP server. If no IP
address is specified, the bindings corresponding to all the addresses are displayed.
Format
show ip dhcp global configuration
Modes Privileged EXEC
User EXEC
Service DHCP The field to display the status of dhcp protocol.