NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
8-74 Switching Commands
202-10102-01, May 2005
sntp unicast client poll-interval
This command will set the poll interval for SNTP unicast clients in seconds as a power of two
where <poll-interval> can be a value from 6 to 16.
Default
6
Format sntp unicast client poll-interval <poll-interval>
Mode Global Config
no sntp unicast client poll-interval
This command will reset the poll interval for SNTP unicast clients to its default value.
Format
no sntp unicast client poll-interval
Mode Global Config
sntp unicast client poll-timeout
This command will set the poll timeout for SNTP unicast clients in seconds to a value from 1-30.
Default
5
Format sntp unicast client poll-timeout <poll-timeout>
Mode Global Config
no sntp unicast client poll-timeout
This command will reset the poll timeout for SNTP unicast clients to its default value.
Format
no sntp unicast client poll-timeout
Mode Global Config
sntp unicast client poll-retry
This command will set the poll retry for SNTP unicast clients to a value from 0 to 10.
Default
1
Format sntp unicast client poll-retry <poll-retry>
Mode Global Config