NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Switching Commands 8-81
202-10102-01, May 2005
no users snmpv3 authentication
This command sets the authentication protocol to be used for the specified login user to none. The
<username> is the login user name for which the specified authentication protocol will be used.
Format
users snmpv3 authentication <username>
Mode Global Config
users snmpv3 encryption
This command specifies the encryption protocol to be used for the specified login user. The valid
encryption protocols are des or
none.
If des is specified, the required key may be specified on the command line. The encryption
key
must be 8 to 64 characters long. If the des protocol is specified but a key is not provided, the user
will be prompted for the key. When using the des protocol, the user login password is also used as
the snmpv3 encryption password and therefore must be at least eight characters in length.
If
none is specified, a key must not be provided. The <username> is the login user name
associated with the specified encryption.
Default
no encryption
Format users snmpv3 encryption <username> <none | des[key]>
Mode Global Config
no users snmpv3 encryption
This command sets the encryption protocol to none. The <username> is the login user name for
which the specified encryption protocol will be used.
Format
no users snmpv3 encryption <username>
Mode Global Config
DHCP Server Commands
These commands configure the DHCP Server parameters and address pools. The commands are
divided by functionality into these different groups:
• Configuration Commands are used to configure features and options of the switch. For every
configuration command there is a show command that will display the configuration setting.