NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
6-2 Quick Start up
202-10102-01, May 2005
System Info and System Setup
Quick Start up Software Version Information
Quick Start up Physical Port Data
Table 6-1. Quick Start up Software Version Information
Command Details
show hardware
(in Privileged EXEC)
Allows the user to see the software version the device contains
Machine Model (The type and number of ports the device provides.)
For example:
Machine Model FSM7328S
24 = 24 10/100 ports
04 = 4 Uplink ports on front of switch
Table 6-2. Quick Start up Physical Port Data
Command Details
show port all
(in Privileged EXEC)
Displays the Ports
slot/port
Type - Indicates if the port is a special type of port
Admin Mode - Selects the Port Control Administration State
Physical Mode - Selects the desired port speed and duplex mode
Physical Status - Indicates the port speed and duplex mode
Link Status - Indicates whether the link is up or down
Link Trap - Determines whether or not to send a trap when link status
changes
LACP Mode - Displays whether LACP is enabled or disabled on this
port.