NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Security Commands 9-21
202-10102-01, May 2005
IP Address IP Address of the configured RADIUS server
Port The port in use by this server
Type Primary or secondary
Secret Configured Yes / No
Message Authenticator Enables or disables. the message authenticator attribute for the selected
server
show radius statistics
This command is used to display the statistics for RADIUS or configured server . To show the
configured RADIUS server statistic, the IP Address specified must match that of a previously
configured RADIUS server. On execution, the following fields are displayed.
Format
show radius statistics [ipaddr]
Mode Privileged EXEC
If ip address is not specified than only Invalid Server Address field is displayed. Otherwise other
listed fields are displayed.
Invalid Server Addresses
The number of RADIUS Access-Response packets received from
unknown addresses.
Server IP Address IP Address of the Server.
Round Trip Time The time interval, in hundredths of a second, between the most recent Access-
Reply | Access-Challenge and the Access-Request that matched it from the
RADIUS authentication server.
Access Requests The number of RADIUS Access-Request packets sent to this server.
This number does not include retransmissions.
Access Retransmission The number of RADIUS Access-Request packets retransmitted to this
RADIUS authentication server.
Access Accepts The number of RADIUS Access-Accept packets, including both valid and
invalid packets, which were received from this server.
Access Rejects The number of RADIUS Access-Reject packets, including both valid and
invalid packets, which were received from this server.
Access Challenges The number of RADIUS Access-Challenge packets, including both valid and
invalid packets, which were received from this server.
Malformed Access Responses The number of malformed RADIUS Access-Response packets
received from this server. Malformed packets include packets with an invalid