NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Switching Commands 8-97
202-10102-01, May 2005
Slot/Port Valid slot and port number separated by forward slashes.
show dot1q-tunnel interface
This command displays detailed information about Double VLAN Tunneling for the specified
interface.
Format
show dot1q-tunnel interface <slot/port>
Mode Privileged EXEC and User EXEC
Slot/Port Valid slot and port number separated by forward slashes.
Mode This field specifies the administrative mode through which Double
VLAN Tunneling can be enabled or disabled. The default value for this
field is disabled.
Customer Id This is a 12-bit customer ID which will be used as the last 12 bits of the
Double VLAN Tunnel. The valid range for a customer ID is 0 to 4095.
EtherType This field represents a 2-byte hex EtherType to be used as the first 16
bits of the DVLAN tunnel. There are three different EtherType tags. The
first is 802.1Q, which represents the commonly used value of 0x8100.
The second is vMAN, which represents the commonly used value of
0x88A8. If EtherType is not one of these two values, then it is a custom
tunnel value, representing any value in the range of 0 to 65535.
show dvlan-tunnel
This command displays all interfaces enabled for Double VLAN Tunneling.
Format
show dvlan-tunnel
Mode Privileged EXEC and User EXEC
Slot/Port Valid slot and port number separated by forward slashes.
show dvlan-tunnel interface
This command displays detailed information about Double VLAN Tunneling for the specified
interface.
Format
show dvlan-tunnel interface <slot/port>
Mode Privileged EXEC and User EXEC
Slot/Port Valid slot and port number separated by forward slashes.