NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
9-20 Security Commands
202-10102-01, May 2005
Format no radius server retransmit
Mode Global Config
radius server timeout
This command sets the timeout value (in seconds) after which a request must be retransmitted to
the RADIUS server if no response is received. The timeout value is an integer in the range of 1 to
30.
Default
5
Format radius server timeout <seconds>
Mode Global Config
no radius server timeout
This command sets the timeout value to the default value.
Format
no radius server timeout
Mode Global Config
show radius
This command is used to display the various RADIUS configuration items for the switch as well as
the configured RADIUS servers. If the optional token 'servers' is not included, the following
RADIUS configuration items will be displayed.
Format
show radius [servers]
Mode Privileged EXEC
Primary Server IP Address Indicates the configured server currently in use for authentication
Number of configured servers The configured IP address of the authentication server
Max number of retransmits The configured value of the maximum number of times a request
packet is retransmitted
Timeout Duration The configured timeout value, in seconds, for request re-transmissions
Accounting Mode Yes or No
If the optional token 'servers' is included, the following information regarding the configured
RADIUS servers is displayed.