NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Switching Commands 8-39
202-10102-01, May 2005
Mode Global Config
no macfilter adddest all
This command removes all ports from the destination filter set for the MAC filter with the given
<macaddr> and VLAN of <vlanid>. The <macaddr> parameter must be specified as a 6-byte
hexadecimal number in the format of b1:b2:b3:b4:b5:b6.
The <vlanid> parameter must identify a valid VLAN.
Format
no macfilter adddest [all | <macaddr> <vlanid>}
Mode Global Config
macfilter addsrc
This command adds the interface to the source filter set for the MAC filter with the MAC address
of <macaddr> and VLAN of <vlanid>. The <macaddr> parameter must be specified as a 6-byte
hexadecimal number in the format of b1:b2:b3:b4:b5:b6.
The <vlanid> parameter must identify a valid VLAN.
Format
macfilter addsrc <macaddr> <vlanid>
Mode Interface Config
no macfilter addsrc
This command removes a port from the source filter set for the MAC filter with the MAC address
of <macaddr> and VLAN of <vlanid>. The <macaddr> parameter must be specified as a 6-byte
hexadecimal number in the format of b1:b2:b3:b4:b5:b6.
The <vlanid> parameter must identify a valid VLAN.
Format
no macfilter addsrc <macaddr> <vlanid>
Mode Interface Config
macfilter addsrc all
This command adds all interfaces to the source filter set for the MAC filter with the MAC addressf
<macaddr> and <vlanid>. The <macaddr> parameter must be specified as a 6-byte hexadecimal
number in the format of b1:b2:b3:b4:b5:b6. The <vlanid> parameter must identify a valid VLAN.