NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
8-14 Switching Commands
202-10102-01, May 2005
System Location Text used to identify the location of the switch. May be up to 31 alpha-
numeric characters. The factory default is blank.
System Contact Text used to identify a contact person for this switch. May be up to 31
alpha-numeric characters. The factory default is blank.
System ObjectID The base object ID for the switch’s enterprise MIB.
System Up Time The time in days, hours and minutes since the last switch reboot.
MIBs Supported A list of MIBs supported by this agent.
snmp-server
This command sets the name and the physical location of the switch, and the organization
responsible for the network.The range for name, location and contact is from 1 to 31 alphanumeric
characters.
Default
none
Format snmp-server {sysname <name> | location <loc> | contact
<con>}
Mode Global Config
System Management Commands
These commands manage the switch and show current management settings. The commands are
divided into two functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration setting.
telnet
This command establishes a new outbound telnet connection to a remote host. The host value must
be a valid IP address. Valid values for port should be a valid decimal integer in the range of 0 to
65535, where the default value is 23. If [debug] is used, the current telnet options enabled is
displayed. The optional line parameter sets the outbound telnet operational mode as ‘linemode’,
where by default, the operational mode is ‘character mode’. The noecho option disables local
echo.