User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
1-2 About This Guide
202-10102-01, May 2005
• Chapter 10, “Quality of Service (QoS) Commands” describes the QOS commands.
Note: Refer to the release notes for the 7000 Series L3 Managed Switch Software application
level code. The release notes detail the platform specific functionality of the Switching, Routing,
SNMP, Config, Management, and Bandwidth Provisioning packages.
Typographical Conventions
This guide uses the following typographical conventions:
Special Message Formats
This guide uses the following formats to highlight special messages:
This manual is written for the Series 7200 L2 Switch according to these specifications:
Table 1. Typographical conventions
italics Emphasis.
bold User input.
[Enter] Named keys in text are shown enclosed in square brackets. The notation [Enter]
is used for the Enter key and the Return key.
[Ctrl]+C Two or more keys that must be pressed simultaneously are shown in text linked
with a plus (+) sign.
SMALL CAPS
DOS file and directory names.
Note: This format is used to highlight information of importance or special interest.
Table 1-1. Manual Specifications
Product Version NETGEAR 7200 Series Layer 2 Managed Switch
Manual Publication Date May 2005
Note: Product updates are available on the NETGEAR, Inc. Web site at
http://www.netgear.com/support/main.asp.
To Next Page
Loading...
