User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Switching Commands 8-35
202-10102-01, May 2005
System Configuration Commands
This chapter provides a detailed explanation of the System configuration commands. The
commands are divided into two functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration setting.
license advanced
This command enables a particular feature. This command also enables the corresponding show
commands for a feature.
Note: If the feature is enabled, the feature is visible in show running-config. The <key> parameter
specifies the hexadecimal key for the feature.
Default
none
Format license advanced <key>
Mode Privileged Exec
no license advanced
This command disables a particular feature. This command also disables the corresponding show
commands. The <key> parameter specifies the hexadecimal key for the feature.
Default
none
Format no license advanced <key>
Mode Privileged Exec
show key-features
This command displays the enable/disable status for all keyable features.
Default
none
Format show key-features
Modes Privileged EXEC
User EXEC
To Next Page
Loading...
