NETGEAR ProSafe GSM7248 - Mode Dot1 Q-Tunnel; No Mode Dot1 Q-Tunnel; Mode Dvlan-Tunnel; No Mode Dvlan-Tunnel

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
8-96 Switching Commands
202-10102-01, May 2005
mode dot1q-tunnel
This command is used to enable Double VLAN Tunneling on the specified interface. By default,
Double VLAN Tunneling is disabled.
Default
disabled
Format mode dot1q-tunnel
Mode Interface Config
no mode dot1q-tunnel
This command is used to disable Double VLAN Tunneling on the specified interface. By default,
Double VLAN Tunneling is disabled.
Format
no mode dot1q-tunnel
Mode Interface Config
mode dvlan-tunnel
This command is used to enable Double VLAN Tunneling on the specified interface. By default,
Double VLAN Tunneling is disabled.
Default
disabled
Format mode dvlan-tunnel
Mode Interface Config
no mode dvlan-tunnel
This command is used to disable Double VLAN Tunneling on the specified interface. By default,
Double VLAN Tunneling is disabled.
Format
no mode dvlan-tunnel
Mode Interface Config
show dot1q-tunnel
This command displays all interfaces enabled for Double VLAN Tunneling.
Format
show dot1q-tunnel
Mode Privileged EXEC and User EXEC