NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Switching Commands 8-73
202-10102-01, May 2005
no sntp broadcast client poll-interval
This command will reset the poll interval for SNTP broadcast client back to its default value.
Format
no sntp broadcast client poll-interval
Mode Global Config
sntp client mode
This command will enable Simple Network Time Protocol (SNTP) client mode and optionally
setting the mode to either broadcast, multicast, or unicast.
Default
Disabled
Format sntp client mode [broadcast | multicast | unicast]
Mode Global Config
sntp client mode
This command will disable Simple Network Time Protocol (SNTP) client mode.
Format
no sntp client mode
Mode Global Config
sntp client port
This command will set the SNTP client port id to a value from 1-65535.
Default
123
Format sntp client port <portid>
Mode Global Config
no sntp client port
This command will reset the SNTP client port back to its default value.
Format
no sntp client port
Mode Global Config