NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Switching Commands 8-45
202-10102-01, May 2005
Format no storm-control broadcast
Mode Global Config
storm-control flowcontrol
This command enables 802.3x flow control for the switch.
Note: 802.3x flow control works by pausing a port when the port becomes oversubscribed and
dropping all traffic for small bursts of time during the congestion condition. This can lead to high-
priority and/or network control traffic loss.
Note: This command only applies to full-duplex mode ports.
Default
disabled
Format storm-control flowcontrol
Mode Global Config
no storm-control flowcontrol
This command disables 802.3x flow control for the switch.
Note: This command only applies to full-duplex mode ports.
Format
no storm-control flowcontrol
Mode Global Config
show mac-address-table multicast
This command displays the Multicast Forwarding Database (MFDB) information. If the command
is entered with no parameter, the entire table is displayed. This is the same as entering the optional
all parameter. The user can display the table entry for one MAC Address by specifying the MAC
address as an optional parameter.
Format
show mac-address-table multicast <macaddr | all>
Mode Privileged EXEC
Table 8-2. Broadcast Storm Recovery Thresholds
Link Speed High Low
10M 20 10
100M 5 2
1000M 5 2