NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Quality of Service (QoS) Commands 10-21
202-10102-01, May 2005
The <dscpval> value is specified as either an integer from 0 to 63, or symbolically through one of
the following keywords: af11, af12, af13, af21, af22, af23, af31, af32, af33, af41, af42, af43, be,
cs0, cs1, cs2, cs3, cs4, cs5, cs6, cs7, ef
.
Format mark ip-dscp <dscpval>
Mode Policy-Class-Map Config
Incompatibilities Mark IP Precedence, Police
mark ip-precedence
This command marks all packets for the associated traffic stream with the specified IP Precedence
value. The IP Precedence value is an integer from 0 to 7.
Format
mark ip-precedence <0-7>
Mode Policy-Class-Map Config
Policy Type In
Incompatibilities Mark IP DSCP, Police
police-simple
This command is used to establish the traffic policing style for the specified class. The simple form
of the police command uses a single data rate and burst size, resulting in two outcomes: conform
and violate. The conforming data rate is specified in kilobits-per-second (Kbps) and is an integer
from 1 to 4294967295. The conforming burst size is specified in kilobytes (KB) and is an integer
from 1 to 128.
For each outcome, the only possible actions are drop, set-cos-transmit, set-dscp-transmit, set-prec-
transmit, or transmit. In this simple form of the police command, the conform action defaults to
transmit and the violate action defaults to drop.
For set-dscp-transmit, a <dscpval>
value is required and is specified as either an integer from 0 to
63, or symbolically through one of the following keywords:
af11, af12, af13, af21, af22, af23, af31, af32,
af33, af41, af42, af43, be, cs0, cs1, cs2, cs3, cs4, cs5, cs6, cs7, ef
.
For set-prec-transmit, an IP Precedence value is required and is specified as an integer from 0-7.
For set-cos-transmit an 802.1p priority value is required and is specified as an integer from 0-7.
Format
police-simple {<1-4294967295> <1-128> conform-action
{drop | set-prec-transmit <0-7> | set-dscp-transmit
<0-63> | set-cos-transmit <0-7> | transmit} [violate-