User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Switching Commands 8-89
202-10102-01, May 2005
Mode Global Config
no ip dhcp conflict logging
This command disables conflict logging on DHCP server.
Format
no ip dhcp conflict logging
Mode Global Config
netbios-name-server
This command configures NetBIOS Windows Internet Naming Service (WINS) name servers that
are available to DHCP clients.
One IP address is required, although one can specify up to eight addresses in one command line.
Servers are listed in order of preference (address1 is the most preferred server, address2 is the next
most preferred server, and so on).
Default
none
Format netbios-name-server <address>
[<address2>...<address8>]
Mode DHCP Pool Config
no netbios-name-server
This command removes the NetBIOS name server list.
Format
no netbios-name-server
Mode DHCP Pool Config
netbios-node-type
The command configures the NetBIOS node type for Microsoft Dynamic Host Configuration
Protocol (DHCP) clients.type Specifies the NetBIOS node type. Valid types are:
• b-node—Broadcast
• p-node—Peer-to-peer
• m-node—Mixed
To Next Page
Loading...
