NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
8-130 Switching Commands
202-10102-01, May 2005
Port Up Time Since Counters Last Cleared Time since port was reset, displayed in days, hours,
minutes, and seconds.
STP BPDUs Transmitted Spanning Tree Protocol Bridge Protocol Data Units sent
STP BPDUs Received Spanning Tree Protocol Bridge Protocol Data Units received.
RST BPDUs Transmitted Rapid Spanning Tree Protocol Bridge Protocol Data Units sent
RST BPDUs Received Rapid Spanning Tree Protocol Bridge Protocol Data Units received.
MSTP BPDUs Transmitted Multiple Spanning Tree Protocol Bridge Protocol Data Units sent
MSTP BPDUs Received Multiple Spanning Tree Protocol Bridge Protocol Data Units received.
show spanning-tree mst port detailed
This command displays the detailed settings and parameters for a specific switch port within a
particular multiple spanning tree instance. The instance <mstid> is a number that corresponds to
the desired existing multiple spanning tree instance. The <slot/port> is the desired switch port.
Format
show spanning-tree mst port detailed <mstid> <slot/
port>
Mode Privileged EXEC
User EXEC
MST Instance ID The ID of the existing MST instance.
Port Identifier The port identifier for the specified port within the selected MST
instance. It is made up from the port priority and the interface number of
the port.
Port Priority The priority for a particular port within the selected MST instance. The port pri-
ority is displayed in multiples of 16.
Port Forwarding State Current spanning tree state of this port.
Port Role Each MST Bridge Port that is enabled is assigned a Port Role for each
spanning tree. The port role is one of the following values: Root Port,
Designated Port, Alternate Port, Backup Port, Master Port or Disabled
Port
Auto-Calculate Port Path Cost This indicates whether auto calculation for port path cost is
enabled.
Port Path Cost Configured value of the Internal Port Path Cost parameter.