NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
Switching Commands 8-77
202-10102-01, May 2005
Server IP Address IP Address of configured SNTP Server
Server Type
Address Type of Server.
Server Stratum Claimed stratum of the server for the last received valid packet.
Server Reference ID Reference clock identifier of the server for the last received valid
packet.
Server Mode SNTP Server mode.
Server Max Entries Total number of SNTP Servers allowed.
Server Current Entries Total number of SNTP configured.
For each configured server:
IP Address IP Address of configured SNTP Server.
Address Type
Address Type of configured SNTP server.
Priority IP priority type of the configured server.
Version SNTP Version number of the server. The protocol version used to query
the server in unicast mode.
Port Server Port Number
Last Attempt Time Last server attempt time for the specified server.
Last Attempt Status Last server attempt status for the server.
Total Unicast Requests Number of requests to the server.
Failed Unicast Requests Number of failed requests from server.
User Account Commands
These commands manage user accounts. The commands are divided into two functional groups:
• Show commands display switch settings, statistics, and other information.
• Configuration commands configure features and options of the switch. For every
configuration command, there is a show command that displays the configuration setting.
disconnect
This command closes a telnet session.
Format
disconnect {<sessionID> | all}