NETGEAR ProSafe GSM7248

User Manual for the NETGEAR 7200 Series Layer 2 Managed Switch Software Version 4
10-26 Quality of Service (QoS) Commands
202-10102-01, May 2005
If the Policy Name is specified the following fields are displayed:
Policy Name
The name of this policy.
Type The policy type (Only inbound policy definitions are supported for this
platform.)
The following information is repeated for each class associated with this policy (only those policy attributes
actually configured are displayed):
Assign Queue Directs traffic stream to the specified QoS queue. This allows a traffic
classifier to specify which one of the supported hardware queues are
used for handling packets belonging to the class.
Class Name The name of this class.
Committed Burst Size (KB) This field displays the committed burst size, used in simple polic-
ing.
Committed Rate (Kbps) This field displays the committed rate, used in simple policing,
Conform Action The current setting for the action taken on a packet considered to con-
form to the policing parameters. This is not displayed if policing is not
in use for the class under this policy.
Conform COS This field shows the CoS mark value if the conform action is set-cos-
transmit.
Conform DSCP Value This field shows the DSCP mark value if the conform action is set-dscp-
transmit.
Conform IP Precedence Value This field shows the IP Precedence mark value if the conform
action is set-prec-transmit.
Drop Drop a packet upon arrival. This is useful for emulating access control
list operation using DiffServ, especially when DiffServ and ACL cannot
co-exist on the same interface.
Mark CoS Denotes the class of service value that is set in the 802.1p header of
inbound packets. This is not displayed if the mark cos was not specified.
Mark IP DSCP Denotes the mark/re-mark value used as the DSCP for traffic matching
this class. This is not displayed if mark ip description is not specified.
Mark IP Precedence Denotes the mark/re-mark value used as the IP Precedence for traffic
matching this class. This is not displayed if mark ip precedence is not
specified.
Non-Conform Action The current setting for the action taken on a packet considered to not
conform to the policing parameters. This is not displayed if policing not
in use for the class under this policy.